Wednesday, 19 November 2008

DIY change from OEM to open pod...

Yesterday,after finished my land law assignment,went downstair to DIY change my stock airfilter to Apexi Dual Funnel Filter...it was kinda easy job from the look of it....but the screw...damn hard to take it off...my hand was literally full of oil,dirt and stuff...



Paper gaskets and manual..

4 screws



The air filter...



adjust the afm to tackle the nut

The Afm..hehe
The stubborn screw..used up 15mins to take it off

Almost an hour later from the beginning of the DIY

The upper part of the filter,dirty ady...due to change..tat why bought the apexi..hehe

the bottom part of it....soil,oil,dirt,sand,dust u name it...

Spot the difference...hehe

anyway...it look small compare to wat i had assume it should be....





the vid....hmm...nt as loud as i expected...oh well....

anyway...after installing it,discover lot of white smoke coming out from the exhaust....so change bck the ori bck to the place...will try to sort out the prob....

4 comments:

april said...

pengsan X.X

Da Devil said...

why pengsan?wakaka...some car stuffs lor...hehe...well this is wat i bought from phillips....hehe

backalleyblog said...

white smoke = this is what you get when you have dusts in your engine rofl.

Da Devil said...

no lar...most probably caused by the engine running too lean...will tackle it later,mayb reset the ecu again,much longer....den see how...